欢迎来到嘉祥同信环卫设备有限公司

当前位置:主页 > 新闻动态 > 常见问题 >

洒水车水泵吸不起水是哪个地方坏掉了?

文章出处:http://www.txhw88.com/ 发表时间:2019-05-15
首先,最有可能呈现的问题就是洒水车滤网梗塞了,由于洒水车装进的水不可能全部是洁净的自来水,可能是脏水池,池塘里抽的水,那样水里杂质太多,滤网易被杂物堵住了,如沙石,塑料袋。只需求把滤网内的滤芯拆下来清洗洁净,即可恢复正常的工作。滤网的位置在洒水车水泵左近。
First of all, the most likely problem is the blockage of the filter screen of the sprinkler. Because the water loaded by the sprinkler can not be all clean tap water, it may be dirty pond and the water pumped from the pond, so there are too many impurities in the water, and the filter screen is easily blocked by debris, such as sand, plastic bags. The normal work can be restored only by removing the filter element in the filter screen and cleaning it. The position of the filter screen is near the left of the sprinkler pump.
再有一个可能就是洒水泵压力缺乏,招致洒水泵抽不起水,洒水泵压力缺乏通常是由两种缘由招致:一、叶轮番道或吸入管路梗塞,也或者是叶轮呈现磨损曾经坏了。二、功率缺乏转速太低。
Another possibility is the lack of sprinkler pump pressure, which causes the sprinkler pump can not pump water. The lack of sprinkler pump pressure is usually caused by two reasons: first, impeller passage or suction pipeline obstruction, or impeller wear and tear has been damaged. Second, the power lacks the speed to be too low.
其实洒水车水泵只需是运转正常,问题普通不大。不能自吸,或吸不上水都是如下缘由形成的,只需用户认真排查,应该很快就能处理。
In fact, the sprinkler pump only needs to operate normally, the problem is not too big. Can not self-suck, or can not suck water are formed for the following reasons, as long as the user carefully checked, should be able to deal with soon.
第一、有可能是泵内引水缺乏或没有引水,加足引水看看。
First, it may be that there is no or no water diversion in the pump, so let's see if there is enough water diversion.
第二、检查吸入的管路能否漏气,特别是球阀衔接处,还有吸入水管的快速接头局部。
Second, check whether the inhalation pipeline can leak, especially at the ball valve joint, and the quick joint part of the inhalation pipeline.
第三、有可能是转速太低,检查变速箱,或加大油门试试。
Third, it may be that the speed is too low, check the gearbox, or try to increase the throttle.
第四、吸程太高。洒水车水泵的最大自吸高度是7米。
Fourth, the suction range is too high. The maximum self-priming height of the sprinkler pump is 7 meters.
第五、吸入管路有可能被异物梗塞。应检查球阀及滤网,清洗滤网,并检查水泵进水口能否也有异物。肃清后再试试。
Fifth, the inhalation pipeline may be obstructed by foreign body. Ball valves and filters should be inspected, filters should be cleaned, and whether there are foreign bodies in the pump inlet. Remove and try again.
第六、检查洒水车水泵能否漏水。假如走漏量很大,就要改换机械密封。
Sixth, check whether the sprinkler pump can leak. If the leakage is large, mechanical seals should be replaced.
最后,检查出水管路,避免管路梗塞,定期清洗检查。
Finally, check the outlet pipeline to avoid pipeline obstruction and clean regularly.
洒水车水泵是洒水车的中心元件。绿化洒水车在工作的时分,水泵是最容易产生毛病的元件。稀有的毛病有,水泵不能吸水和不能出水两种。
The sprinkler pump is the central component of the sprinkler. When the green sprinkler works, the water pump is the most vulnerable component. Rare faults are that the pump can not absorb water and can not discharge water.
请依照以下步骤逐渐检测
Follow these steps to gradually detect
1.洒水车不能吸水。
1. The sprinkler can't absorb water.
a.检查洒水车水泵吸水口和出水口开关能否翻开。
A. Check whether the water pump suction port and outlet switch of sprinkler can be opened.
b.洒水车水泵为自吸泵,第一次运用时分要灌引水的c.检查吸水管前段滤网能否有杂物梗塞进水口。
B. The sprinkler pump is a self-priming pump. When it is used for the first time, C. Check whether the filter in the front of the suction pipe can obstruct the intake.
二手洒水车
d.逐段检查进水管路能否密封,扫除漏气中央的毛病。
D. Check whether the intake pipeline can be sealed step by step to remove the central leakage.
e.普通洒水车运用的水泵引水高度应小于5米。
E. The diversion height of pumps used by common sprinklers should be less than 5 meters.
f.检查洒水车水泵油密封件能否损坏,泵轴渗漏影响其真空度应改换密封件。
F. Check whether the oil seal of sprinkler pump can be damaged or not, and the vacuum degree of pump shaft is affected by leakage, the seal should be replaced.
g.洒水车发起机转速太低。达不到所需的真空度,调整油门使转速在1700转/分左右,变速箱不同可能请求的发起机转速不同。
G. Sprinkler starter speed is too low. Unable to reach the required vacuum, adjust the throttle so that the speed is about 1700 rpm. The speed of the engine varies according to the different requirements of the gearbox.
h.检查洒水车取力器能否工作,取力器和传动轴脱离会形成水泵不能工作。
H. Check whether the sprinkler power take-off can work or not. If the power take-off and transmission shaft are separated, the pump will not work.
i.检查洒水车水泵转速能否正常,有没有异常响声。转不动的话多是有杂物缠绕叶片了.
I. Check whether the pump speed of the sprinkler is normal and whether there is any abnormal noise. If you can't turn around, there are many sundries winding the blades.
另外在检测过程中防止水泵长期空转,形成水泵温渡过高影响其寿命。
In addition, in the detection process to prevent long-term idling of the pump, the formation of excessive temperature of the pump affects its life.
2.洒水车水泵不出水, 这个问题同样需求触及到上述几点。还有几点可能性:
2. Sprinkler pump does not water, this problem also needs to touch on the above points. There are several possibilities:
a.洒水车水罐太脏,出水口滤网或泵体梗塞冬季运用洒水车需要排尽水罐和泵体内积水,否则可能招致罐体内部和洒水车水泵结冰和冻裂。
A. Sprinkler tank is too dirty, outlet filter or pump body infarction in winter use sprinkler need to drain water tank and pump body accumulated water, otherwise it may cause tank body and sprinkler pump freezing and cracking.

返回顶部