1. Add smooth oil to small manure truck. The daily operation of the engine is inseparable from the nourishment of smooth oil. The driver must make sure to change the smooth oil for the engine every 5000 km or no more than half a year. If the smooth oil is found to be turbid or lacking during daily driving, it should be stopped at any time to avoid the formation of engine parts wear.
2. The cover plate of the starter of the small-scale manure suction truck. After the new car leaves the factory, we suggest that you should buy a starter cover plate, which can avoid the collision of the starter when the stone or the terrain is low. Physical guarantee to reduce engine damage caused by external impact elements.
3. Cleaning of a small manure truck. Driving small-scale manure truck products to the manufacturer to clear the carbon deposit of the engine every 20000 kilometers is one of the effective ways to improve the engine power. In the daily driving process, carbon deposits and crud formed due to unclean fuel or other reasons can reduce the power level of the driving force.
4. Driving habits. In addition to the above points, the driving habits of the staff will also affect the service life of the engine of the small-scale manure truck at a certain level. We suggest that all staff members should try to prevent sudden acceleration or deceleration when driving! It is best for the engine to maintain a steady and even speed.
When the chassis parts of the suction truck are damaged in the field or far away from the repair site, the following emergency measures can be used to drive the small suction truck to the center of the repair conditions according to different fault conditions.
In case of leakage of brake fluid in the brake cylinder of the small-sized manure truck or breaking of the pipe of the pump, a small pad can be made of iron sheet and copper sheet at the pipe joint of the pump to block the pipe, and then screw up the screw, or clamp the fracture flat and curl to block the leakage, so that the wheel can not be used for braking. But this may form a single side brake, driving a small suction truck to pay attention to safety.
The brake master cylinder of small-scale manure truck is short of brake fluid, which can be replaced by alcohol or liquor, and can be replaced by clear water under special conditions. The brake cup of the small-scale manure suction truck is swollen. Soak the swollen cup in hot water for 10-20 minutes, and remove the oil content from the cup, so as to restore the size of the cup.
The friction plate of the clutch of the small-sized manure suction truck is eroded and skidded, and the friction plate which is not seriously eroded can be turned over for use. If the ablation is serious, cotton cloth or canvas can be used for several layers (the thickness should be different from the original friction plate), and steel wire or wire can be used to pass through the holes on the steel plate to fix it. When driving a suction truck, it should start smoothly and shift quickly.
The tie rod ball joint of the small-sized suction truck is broken. In the bumper or other places that do not affect the driving of the suction truck, remove a screw similar to the total length of the ball joint to replace the broken ball joint. After the steering knuckle arm and nut are installed, rivet the exposed part of the screw with a hammer. If the differential gear of the three axle suction truck is damaged, for example, any differential of the middle and rear axle is damaged, the transmission shaft and the half axle of the axle can be removed to continue driving. If the front differential is damaged, remove the small fecal absorption wheel hub and continue driving.
The wonderful content of this article is provided by the knowledge provided by the second-hand manure truck. There are many wonderful contents in this website. For more contents, you can click to enter: https://www.txhw88.com We have special customer service to answer your questions